Well I finally upgraded my firmware to 7A14 Saturday and everything was running fine sooooooo this morning I enable logging on 3 ~ 4 outlets and when I save the last one *poof* controller is disconnected from Fusion, local web pages server and phone app... I will have to go home @ lunch and reset it...
At lest it is still running from what I see on my cams....
OK so the return pump and lights are not running but the circulation pumps are. Unfortunately I have the controller programmed such tat if the return is of they are off as well. The display is dead and I am trying to reboot the controller. I have unplugged all the modules and plugged them back in slowly but to no avail... I will open a ticket with support also..
VERY FRUSTRATING>>>>
So I had to reflash the latest firmware and update the webpages to get my controller working again. I disabled logging on the 3 outlets and I wish this issue would get fixed...
Posting Permissions
Reply With Quote
Bookmarks