Any chance we can get the connector that works with the DOS tubing that you are using on the DDR for an application we already have?
Any chance we can get the connector that works with the DOS tubing that you are using on the DDR for an application we already have?
Are you asking about the push-fit fitting? They are readily available. Even Home Depot and Lowes have them. I get mine from US Plastic: http://www.usplastic.com/catalog/def...arentcatid=967
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
I do have some of those 1/4" push to connect fittings but thought I had read that some of those type weren't the right size. That they were letting in air and not making a good seal due to the different size of tubing that the DOS was using.
The DOS pumps have a totally different fitting than the DDR.
As for the push-fits, YMMV - I tried some Witt brand 1/4" ones from HD (which are overpriced and of lower quality, IMO), and had come issues with one type of 6mm tubing, but other 6mm & 1/4" tubing was fine. The Parker brand ones I got from USP worked fine with all 4 types of tubing I tried.... Neptune tuning, 2 different brands of 6mm OD polyurethane tubing, and standard 1/4" polyethylene RO tubing.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Thanks for the info RussM. I just need to work on getting it set up.
Bookmarks