change fanspeed to the temperature
I need to install a vent fan and I'm wondering if it'spossible to use the Apex's variable output (0-10volt) to control the fan speedand change the speed to the temperature?
I was going to use this one:
Propeller Control enables the ProfiLux controller to operatethe PropellerBreeze with variable speedcontrol.
Propeller Control is connected to a 1-10V–interfaceof the ProfiLux (beginningfrom Plus (II).
With Propeller Control connected to ProfiLux, the PropellerBreeze willautomatically adjust its fan speed according to how much the nominaltemperature is exceeded. Therefore, the fan alwaysrotates as fast as necessary andas quietly as possible.
https://www.aquariumcomputer.com/products/aquarium-fans-propellerbreeze/
change fanspeed to the temperature
The pins will not be correct for the RJ11 plugged into the RJ45. You’ll need to make a new cable or modify the one you have. There is a pinout diagram in one of the stickies here at the top of the DIY forum.