Just a little bit of help!
Hello everyone!, I'm really new to all of this controller stuff, I seem to have come unstuck with my return pump programing, just to mention but one.
I have a 75gal aquarium, using a COR 20 running at about 25% of its output, which works fine. I too have a pair of siphons using a vacuum pump to keep the siphon active in case of siphon break. I'm using this method cause I could not drill my tank owing to plate glass walls.
I placed a float switch in one corner of the tank and can't seem to get it all to work together.
I've tried to put together a little programing, but to be honest I'm no programmer by any stretch of the imagination.<br>This is what I have, but each time I try to use it shuts the pump down and fills my sump.
Fallback ON
Set ON
If FeedA 010 Then OFF
If Mntrip (Sw2) CLOSED Then OFF
DEFER 001:00 Then ON.
If anyone can correct me I'd be most grateful.
As I understand it, the first two lines turn the pump on 24/7, if the feeder is activated it will stop all for 10 mins. After which when the pump restarts if it fills to much which activates the float switch, it will stop the pump for a short spell allowing the water level to settle before starting up again.
Thank you in anticipation of anyone being able to help me.