1 Attachment(s)
Not able to toggle switch on Break Out Box
Hi,
I purchased the new Apex unit (not the classic) as well as the break out box. After getting the apex head unit updated with the latest firmware last night, i wired the break out box to the LED light strip that would turn on if i open my cabinet turns. but for some reason, none of the switches (SW1-SW6) would toggle. did i miss something?
Attachment 7435
Not able to toggle switch on Break Out Box
https://uploads.tapatalk-cdn.com/201...fae3276e73.jpg
Notice there are only 6 inputs, 1 rsv (reserve) and 1 gnd, one end off all the switches go to GND and the other ends of switches go to seperate inputs (I drew them going into 3, 5, and 6, so if you wire your door switch like that say number 6, 1 wire to GND and the other wire to i6, then change the sw7 part of your program to sw6, it should work when set to auto, depending on if you have used NO or NC you may have to change the if open or if closed part aswell
Not able to toggle switch on Break Out Box
If I have 2 magnetic switches, one per door, how do I go about to wire them to each other and then to the break out box? The intended functionality is that if either door is open, the light gets turned on. Of course I can use another switch in the breakout box, but is there a way to do with with just one switch in the break out box?
Sent from my iPhone using Tapatalk