What/where can I get cable to sync my MP40wES to my APEX?

[Turok]

Got my Apex yesterday..
trying to hook everything up.
I got the WXM wireless module.
I can not find the cable to connect the MP40wES to APEX to sync/reset. I NEED THE CABLE. where can I get one? what is it?

I thought it would be the same as the Radion to APEX cable, that was my last question here on this forum. But it's round? connection.

[RussM]

There is no such cable. The WXM and Vortechs communicate wirelessly.

[jonmos75]

I can not find the cable to connect the MP40wES to APEX to sync/reset. I NEED THE CABLE. where can I get one? what is it?

What cable are you refering too???

WXM communicates to your MP40 controller via wireless

Check out these two places for more info:

https://www.neptunesystems.com/downl...WXM_manual.pdf

http://neptunesystems.freshdesk.com/...via-apexfusion

[RussM]

https://www.neptunesystems.com/vortechgs/

[Turok]

Okay, I skipped trying to update the firmwave and went straight to pressing the buttons for the pumps. Didn't look like it did anything... BUT Wait. I went to my Fusion account and both my LEDs and MP40 were listed. Saved a trip and 15 bucks to the LFS...

[daveh2o]

Can someone confirm om my mp40 i have 3/4 inch glass do i leave the rubber pin spacer off and not use it at all ???

[daveh2o]

I know it says to not use it but seems like the rubber spacer would help take out vibration ?

[RussM]

The MP40 manual says "3/4" (19mm) thick aquariums DO NOT use the pin spacer". I'd suspect that if you leave the spacer in, the magnetic bond between the wet and dry sides won't be strong enough to hold the two sides in place and properly aligned.

[daveh2o]

Thanks and sorry bout that russ

[daveh2o]

It does hold it and works thats what seems confusing