Vortech MP10 Powers off with Outlet set to "Auto"

[Chris64]

My MP10 loses power when I set my outlet to "Auto". Below is a screenshot of my outlet and my module. Can anyone assist in diagnosing the problemScreen Shot 2015-02-28 at 1.45.34 PM.pngScreen Shot 2015-02-28 at 1.48.51 PM.pngScreen Shot 2015-02-28 at 1.52.47 PM.pngScreen Shot 2015-02-28 at 1.54.47 PM.png

[Alain B]

Your outlet MP10wes_3_3 is wrong , this is most likely the power brick outlet of your pump ?

Use :

Fallback ON
Set ON

Leave this one to AUTO .

Use the programmable pump outlet ( Vortech_4_1 ) for any programming .

[RussM]

There's no need to even use an EB outlet for Vortechs.

[Chris64]

Thanks Alain. That did the trick. Guess I am still learning the Fusion interface.

Your outlet MP10wes_3_3 is wrong , this is most likely the power brick outlet of your pump ?

Use :

Fallback ON
Set ON

Leave this one to AUTO .

Use the programmable pump outlet ( Vortech_4_1 ) for any programming .

- - - Updated - - -

Understood. Being new to the Apex system just assumed that I would run all pumps through the EB8. Thanks for the advice.

There's no need to even use an EB outlet for Vortechs.

[RussM]

You can use an EB outlet if desired for the sake of convenience, but if you do it should simply be programmed as Alain described.