As you can see after
Fall back
Then follow by probe name ,high value , low value ,on when ;
But where I Can I find this window for me to write input as you mentioned ;
Huh ! Sorry I am a newbie in apex and It need some more of your patience but i appreciated very much for your help , kindly guide me to reached there!
Sent from my iPhone using Tapatalk
You are trying to set this with an iphone ? Maybe you could try with a pc or mac it would be easier .
Alain
This is a shot from my iphone :
IMG_3499.PNG
Alain
I found it and this is the initial setting ;
Can I copied yours ? But our naming is not the same because I have 2 ph probe ;
Ph : for calcium reactor
Ph2 : for my tank
Furthermore in your command #5 and #6 what is this and if it necessary to write that command too?
Sent from my iPhone using Tapatalk
Make this in your outlet :
Fallback OFF
Set OFF
If ( Name of your probe ) < 6.90 Then ON
Alain
So in this case the name of my probe is Ph then I just write "Ph"
Sent from my iPhone using Tapatalk
Yes , use the EXACT name of your probe .
Alain
Ok , this is the new one;
And this is after I hit update:
Sent from my iPhone using Tapatalk
Thanks and I will report back after 24 hours and show graph. Hope it will be the sawtooth pattern .
Thanks my friend!
Sent from my iPhone using Tapatalk
Yes I did uploaded the programming as mentioned above and here again the windows after uploading ;
Thanks again!
Sent from my iPhone using Tapatalk
By the way as the commas said ;
If PH < 6.90 then on ......
So it means that the co2 Doser will ON if ph is like 6.89?
Because I observed that my PH now is 7.02 and the calcium reactor or co2 doser is OFF
Sent from my iPhone using Tapatalk
Yes
Sent from my iPhone using Tapatalk
But if I set it to Auto now is off. I supposed the command should be set it as ;
If PH <6.90 then OFF
Sent from my iPhone using Tapatalk
Ok , thanks
Sent from my iPhone using Tapatalk
Ok Thanks . My main problem I think is the effluent rate that it has to readjust every 3 to 5 days due to clogging as the drip varies from 15 ml/ min and it reduced to abt 10 ml/min if leaving it in 5 days or so
Sent from my iPhone using Tapatalk
What kind of pump are you using for effluent ?
Alain
Actually , I only relay on this ball valve to control the drop which is the reason why my reactor is not consistent due to clogging that I need to make adjustment to maintain the effluent rate of 15ml/ min.
I am thinking of using the cheap china made Jebao dosing pump to pull the effluent consistently of which I will use all the 4 pumps to alternately running 24/7 as I need 21.6 liters / day to maintain my KH requirement.
Sent from my iPhone using Tapatalk
This is exacxtly were your problem is located . I doubt much a Jebao pump will last more then a few months and supply enough flow in the best scenario . Calcium reactor need to run 24/7 non stop . Get a brush less DC variable speed peristaltic pump and your problem will be solve .
Alain
Bookmarks