Hey everyone, first real go around with the programming here so I apologize for simplistic errors in advance.
I have a redsea max s650 that has a built in ato chamber of 10 gallons. I'm looking to outfit this chamber with 3 float switches to automate the RODI refilling of this chamber.
My thought is to have the lowest float turn on an outlet that opens 2 solenoid valves (for redundancy) to begin filling the chamber until the middle float valve is opened which will then close both valves. It will not refill until the lowest float valve is then closed (lowest position=closed). I additionally want to install a 3rd float valve above the other 2 as a fail safe so that if the highest float valve is closed then it will additionally close the solenoids and trigger email alarm.
ATOLO valve is open when no water present
ATOHI valve is closed when no water present
ATOEM valve is open when no water present
Is this the correct orientation of the floats? or should I change them?
On the outlet for the solenoid I have the following:
Fallback OFF
If ATOLO CLOSED Then ON
If ATOHI OPEN Then OFF
If ATOEM CLOSED Then OFF
on the base email "outlet" i have
If ATOEM CLOSED Then ON
Any suggestions/corrections is greatly appreciated!
Thanks in advance
Bookmarks