'Lo all,
Does this happen to anyone?
I use Pipeline mode. Every now and the pump will turn on then stop. Then pick up again when it is it's turn.
Happens all the time.
Latest firmware, etc.
'Lo all,
Does this happen to anyone?
I use Pipeline mode. Every now and the pump will turn on then stop. Then pick up again when it is it's turn.
Happens all the time.
Latest firmware, etc.
I thought I noticed this once or twice but thought it was just me. I thought I read on another thread that there would be an update released soon that includes an update for the WAV's.
Sent from my iPad using Tapatalk
I am noticing this more and more. Often my pumps won't make it past the full time allotted for the pipeline.
Contact tech support.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Called and they fixed the problem by giving me a non published firmware. All works better now.
My right WAV has been doing this. I never have it below 15% but it randomly turns on and off. Seems to always be in the afternoon when I notice it because it makes a clicking sound. I change it to Maverick mode from Rincon and increased the power to see if that makes a difference.
You should install the newly-posted firmware. It contains updated WAV firmware which fixes the issue. https://forum.neptunesystems.com/sho...sion-4-40_AA15. After installing the new Apex system firmware, be sure to update the WAVs' firmware as instructed in the linked post.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Did you load the new beta FW that Paul posted earlier today?
https://forum.neptunesystems.com/sho...sion-4-40_AA15
Jon
RussM, thanks for the quick reply. I have updated the FW and haven't heard or witnessed the WAV cycle power since. I will keep an eye out and update later this week. JP
Bookmarks