I am trying to use my unit for a ATO on my tank. I am currently using a AC3 Pro unit and I cant get the BOB to work at all. It has GND, RSV, and 6-1 plugs on it. I connected the Float valve to 1 and the GND and the second float valve on gnd and 2 port and used this program for the ato. The BOB is pluged into the I/O socket on the AC3. The AC3 also has the lastest firmware 3.4 on it.
Fallback OFF
Set OFF
If Sw1 CLOSED Then ON
If Sw1 OPEN Then OFF
I get an error message for the fallback and Set line, so I deleted them but still no response from the unit. It is as if the BOB is not even there. Maybe the AC3 pro cant use a BOB unit?
Any help would be greatly appreciated here. Thanks.
Bookmarks