Page 2 of 2 FirstFirst 12
Results 26 to 26 of 26

Thread: Float switch mounting

  1. #26
    Marine Aquarist FLSharkvictim's Avatar
    Join Date
    Jun 2016
    Location
    Redington Beach, FL
    Posts
    95

    Ato / float switches

    I use a TUNZE 3155 ATO - BULLET PROOF along with a 3rd float switch that's connected to my Breakout box on my Apex! Just in case my TUNZE 2nd line of defense does not shut off my ATO which it will b/c I have it set to automatically shut off after 1 minute of running. Also, just in case I have a 3rd float switch installed. Then my RODI, is hooked into my Eshoops 5 gallon container that has two float switches in it. Redundancy, Redundancy, Redundancy!!!
    Attached Images Attached Images

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Question: Float switch
    By drex in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 1
    Last Post: 10-31-2015, 16:31
  2. Question: Mounting a Float inside of NSW Resevoir
    By iamchadster in forum AquaBus Modules, Probes, and Breakout Boxes
    Replies: 2
    Last Post: 02-23-2015, 04:48
  3. Float mounting in overflow
    By Jstorey in forum Apex Installation and Mounting
    Replies: 7
    Last Post: 08-15-2014, 21:10
  4. Question: Float Switch
    By CPD1029 in forum Misc Aquarium Automation Discussions
    Replies: 2
    Last Post: 03-09-2014, 12:12
  5. Float valve mounting
    By gregr in forum DIY
    Replies: 14
    Last Post: 12-22-2013, 17:41

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •