issues programming ph probe in calcium reactor

[Hybridazn]

hello everyone, I am trying to program my apex to turn on and off my co2 regulator and I am having some problems that aren't making sense to me. The probe in the reactor is pH2 and is enabled and is logging and reading fine. When I go to program using either the advanced or just the basic ph setup it will not allow me to program using "pH2" but if I use any of my other ph probes it will go thru.

Any help will be greatly appreciated

[surf_and_turf]

Hey there. I did the same thing, and got the same error. It's a know issue with the way the name of the probe. Rename your probe to pH_CaR, or something like that.

[RussM]

Rename your probe to pH_CaR, or something like that.

+1

This is the solution.

[Hybridazn]

Yup that was the issue, thanks everyone!

[916gman]

I stuck with same problem how you change from pH2 to pH_CaR or something else?

hello everyone, I am trying to program my apex to turn on and off my co2 regulator and I am having some problems that aren't making sense to me. The probe in the reactor is pH2 and is enabled and is logging and reading fine. When I go to program using either the advanced or just the basic ph setup it will not allow me to program using "pH2" but if I use any of my other ph probes it will go thru.

Any help will be greatly appreciated

[Hybridazn]

I changed it to pHx2

[fab]

I changed it to pHx2

... And???

[Hybridazn]

... And???

I'm not following here....

I changed the probe name from pH2 to pHx2 and it fixed the programming issue.

[916gman]

I'm not following here....

I changed the probe name from pH2 to pHx2 and it fixed the programming issue.

Thanks that is change my to pH_CaR is work

===> From your apex display go to setup - then - pH - then pH name hit arrow down and you see pH2 then change to what you like good luck