Im having trouble getting my Energy Bar up and running.
I've had the APEX system itself running for 6months with the usual probes 2xTEMP, PH, ORP, Salinity etc.... I have the powerbar connected but have not used it for anything until now.
I want to get the heater running first so thought i'd connect a light to the channel I'm planning to sue so i can confirm visually that it was working as desired based on temp before connecting the actual heater.
However what ive found is it does not matter what temp the water is the light (replicating heater) just stays on. I tried the simple way and then studied up the more advanced way using code but neither seem to matter its like its jammed on. Any suggestions?
Screen shot below of the current configuration.
https://scontent-syd1-1.xx.fbcdn.net...61&oe=5873C82A
Bookmarks