I have added a second pH probe for my calcium reactor and named it pH2 using the Apex display. I have pH2 showing up on my Fusion Dashboard as well as an option on the PH control wizzard but I keep getting an error when I try to use pH2 in my programming. Any ideas?
Here is the code I am using and the error message I am getting.
Fallback OFF
If pH2 > 7.0 Then On
If pH2 < 6.9 Then Off
If pH1 < 7.8 Then OFF
Send Failed
//Error: line 2 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Par, Feed, SwX, Error, Power, Sun, or Moon // If pH2 > 7.0 Then On //Error: line 3 - Valid keywords following If are Temp, pH, ORP, DO, Cond, Par, Feed, SwX, Error, Po
Bookmarks