Ok, need assistance.
Current state/programming:
I have my pmup sitting in my rodi container. There is an avast ato sensor (sw1) that has been programmed so that when it closes, it turns on.
current programming:
Fallback OFF
Set OFF
If Sw1 CLOSED Then ON
If pH > 8.60 Then OFF
Target state:
I'm losing 8 cups a day to evap. I'd like to turn the pmup on to cover that but do it little by little across the day for obvious stability reasons. What does the programming look like if I'm also using the above code as a general topoff?
Basically I believe this is what I am looking to program:
Part 1:
Turn on pump for 5 seconds 18x a day (needs 90 seconds to pump 8 cups) avoiding from 12-6pm due to highest PH.
If ph is high, don't run
Part 2:
If the sensor says water is low, turn on pump.
If the ph is over 8.6, turn off
Bookmarks