Can I use Barbed fittings on the Flow sensor and place it inline? I would assume if my Tubing is 1"inch using barbed fitting of 1"inch or will I need to make sure 5 Inches on both side and solid pipe is used?
Thanks
Can I use Barbed fittings on the Flow sensor and place it inline? I would assume if my Tubing is 1"inch using barbed fitting of 1"inch or will I need to make sure 5 Inches on both side and solid pipe is used?
Thanks
This should work just fine.
I will let everyone know the results.
No issues putting them in. I placed a 1inch with barbed fittings without any issues. Pretty much added approx 3 inches on each side.
I did also a 1 inch also on a 3/4. I did 3 inches of pvc on both sides with the barbed fitting which added another 1 inch and again no issues.
I can provide pictures if you want to see them also.
IMG_0948[1].jpgIMG_0947.jpg
No issues installing them on Vinyl tubing. I have one for my Reefgium and the other is on the return to the tank.
I also have a 1/4 on my ATO.
Last edited by KRoss; 04-23-2017 at 12:38. Reason: Photos
Bookmarks