So this question is not directly Apex related, but I will be using it to control the pumps. Building a new tank and want to run the ATO remotely from my garage instead of having a reservoir under the stand or beside the tank.
I just ran the lines through the attic today (1/4 inch) and they are inside pool hose to stop the lines from sweating. Also have a high point so the water should drain out and not hold heat.
My question is on the pump required to be able to do this. I have the apex reservoir pump which is rated at 14 ft head, but I'm not sure this will be able to push the water. The height is not much over 14ft and should be under 16ft, but the distance is 65-75 ft that is will have to go. Typical range house single story but garage is on one side and living room is on the other.
Wondering if anyone else has done a similar setup or has some thoughts.
Thanks,
Bookmarks