I am looking for two cables, one to connect an apex-ready Waveline to the VDM, and another to connect a Reef Octopus Varios. Can someone point me in the right direction?
I am looking for two cables, one to connect an apex-ready Waveline to the VDM, and another to connect a Reef Octopus Varios. Can someone point me in the right direction?
180g reef with all the bells and whistles
The waveline Apex ready controller accepts a regular CAT5 ethernet cable with RJ45 ends but that will use up 2 Var Speed ports for only 1 pump.
Waveline also has a splitting or Y cable similar to the Varios cable but terminated with 2 RJ45 ends which gives you back both Var ports. I got mine at Coralvue and they ca be had in 3m and 6m lengths.
http://www.coralvue.com/waveline-apex-cable
Ok, don't know what some of these jokers have been smoking....but here's what worked for me:
1. Make one end of the ethernet cable to T568-B specs.
On the other end:
1. For VSP1 pin positions 5 & 6 with blu /whi (5) grn (6) [5 is + voltage and 6 is ground]
2. For VSP2 pin potions 5 & 6 with org/whi (5) & org (6). [5 is + voltage and 6 is ground].
As always check with voltage meter with VSP sliders to ON position for around 10 vdc, prior to crimping.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I should also note that I have the Apex 2016
Sent from my iPhone using Tapatalk
Bookmarks