While searching for an answer to my situation, I cameacross this thread. I have a RS 750 XXL that I just started up with anApex 2016 and Flow meter/FMM. It has a Sicce SDC 9 return pump and the flowmeter installed with 1" vinyl tubing on each end. The pump iscurrently running at about 40%. My Apex shows the flow meter reading0. I'm not sure if there is back pressure causing the flap to stay open. I say this because on the exit end of the return, I installed loc linewith the small exits on each segment. I have turned the pump onand off to see if this dislodges the flap, with no luck. My next courseof action is to remove this loc line and install the stock one and see if itmakes a difference. If that doesn't work I will have to disconnect thepump and manually dislodge the flap. (Could not load picture of the loc line)
Bookmarks