I control my kessils with the SUN command and I have a ramp profile for each one of my stages (thanks from another forum).
Set OFF
If Output ATTINIC = ON Then ATTINIC_POW
If Sun 120/-240 Then Int_Rise
If Sun 480/120 Then Int_Set
If Sun 360/-060 Then Int_Day
If EMERGE CLOSED Then OFF
My Int_Rise is a ramp up of 240 minutes.
My question I was testing some power outages, and I disconnected everything, when I plugged back everything, it seems my variable output is on the right stage of my programming, but it seems the RAMP up started again from from the percentage I have it close to 0%. Is that normal or a way to prevent it?
Bookmarks