Results 1 to 2 of 2

Thread: Setting kessil mode during feed mode?

  1. #1
    New User
    Join Date
    Sep 2015
    Location
    North Carolina
    Posts
    5

    Question Setting kessil mode during feed mode?

    I have a pair of kessil a360's connected to the controller and run through the variable outlets.i have one of my feed modes set to feed corals, in which I want it to turn the lights on to a low intensity during. I've just been manually turning them on, but that turns them on full intensity. How would I go about having them turn on auto with the feed mode, then resume their normal program after?

  2. #2
    Frequent Visitor riverchemistry's Avatar
    Join Date
    Jan 2014
    Location
    under the sea
    Posts
    91
    You'll want to create a PROFILE

    go to the profile section of your APEX fusion. Pick a profile and call it 'LightFeed'
    Set it to be RAMP
    Set START and END intensity to 20%
    Save.


    Then after go to your Kessils Switches on your dashboard. go into their programming by switching their CONTROL TYPE to advanced.
    At the very bottom of the programming you're gonna write up.

    If FEEDA 000 Then LightFeed

    Then save. What this is going to do is whenever the FEED A is clicked. your lights are gonna dim down to 20%. Because of that LightFeed profile you created and are referencing in this program line here at the bottom. But, I'm guessing you're using FEED A. If you're using another letter B C or D than just change the letter according to what you use for FeedMode.

Similar Threads

  1. Help with setting up feed mode for cor20
    By Diveshaman in forum COR-15 & COR-20 Pumps
    Replies: 11
    Last Post: 12-24-2020, 17:34
  2. Question: Setting Feed Mode for Multiple Feedings
    By Jake_francis in forum Misc Apex Usage & Programming
    Replies: 1
    Last Post: 04-22-2019, 06:46
  3. Help! Turning Kessil A360 to specific Int/Col during a feed mode for coral viewing
    By Travel in forum Apex Programming for Lighting
    Replies: 9
    Last Post: 02-06-2019, 20:24
  4. Question: Feed Mode A - Turn on XF250 at a slow speed with ICE CAP wtih Alternating Gyre Mode
    By imfsub12 in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 8
    Last Post: 05-01-2018, 18:27
  5. Question: I need help programming my MP10 and MP40 for feed mode/ nutrient transport mode
    By Koddie Doo in forum Apex Programming for Vortech, Tunze, & Other Controllable Pumps
    Replies: 5
    Last Post: 01-08-2018, 16:02

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •