So I had a power outage this morning that lasted around two hours. When the power came back, my ATO kicked on but my FMM was off (no green light). When I checked Fusion, my sensors disappeared from the dashboard. When I checked the apex classic page, there were two FFM modules created (9 and 10), but both were disabled as there was no power on the FFM module. I unplugged the FFM from the aquabus cable and replugged it and it turn on again, but it renamed my switch names to the default name.
Did I set it up incorrectly that it would kick my ATO on when the module is off? I also noticed that my T5's came on at 8:30 AM after the power outage. They usually come on at 1 PM, but after a few minutes, they shut off. But the FFM issue still persisted.
Here is my ATO pump programming:
Fallback OFF
Set OFF
If OS1 OPEN Then ON
If OS2 CLOSED Then OFF
If HIGH CLOSED Then OFF
Defer 002:00 Then ON
Min Time 006:00 Then ON
Any thoughts are highly appreciated!
Bookmarks