Originally Posted by
p7willm
The problem is in your code for SwStuckCL. There should not be a Set OFF in the outlet. The way it stands now when the ATO runs for 40 seconds SwStuck comes on and the ATO shuts off, now since the ATO is off SwStuck turns off, the ATO comes back on and the cycle starts again.
You want to take the Set OFF out of SwStuckCL, That way when it is turned on by the ATO being on for 40 seconds it stays on. You also want to add
If Outlet vReset = ON Then OFF
to Sw StuckCL. vReset is a virtual outlet that has no code. It is normally OFF in Fusion but when you have fixed an ATO problem and want it to run again swithc vReset to ON in Fusion for a few seconds and SwStuchCL will shut off.
You want SwStuck to come on if there is a problem with the ATO and keep the ATO off until you fix the problem and then use Fusion to reset things.
Bookmarks