Hello,
Would someone kindly guide me how to setup 2 wavs in reverse operation. As in WAV 1 on for 10 seconds then WAV 2 on for 10.
Btw I just got these heads and they are beyond amazing. Very quite
Thanks !
Sent from my Pixel XL using Tapatalk
Hello,
Would someone kindly guide me how to setup 2 wavs in reverse operation. As in WAV 1 on for 10 seconds then WAV 2 on for 10.
Btw I just got these heads and they are beyond amazing. Very quite
Thanks !
Sent from my Pixel XL using Tapatalk
Set the master pump the way you like , and set the slave to inverse 100% , they will work the same but in opposite way .
Alain
Thank you
Sent from my Pixel XL using Tapatalk
Alain,
Follow-up questions.
My master pump will not pulse although I have it programmed to. Inverse set on slave @ 100. It's a constant flow on the master. Any ideas? Flowing constant at 30
Sent from my Pixel XL using Tapatalk
Salve is pulsing
Sent from my Pixel XL using Tapatalk
Maybe reverse config? Or switch ports?
Sent from my Pixel XL using Tapatalk
Forget the slave as for the programming , concentrate on the master . How do you set the master pump ? Can you post a screenshot of the pump graph ? Like the one i am just posting . In addition , any pump can be master or slave , it's up to you to decide which one . Capture pump.PNG
Alain
Here
Sent from my Pixel XL using Tapatalk
Here is a screenshot of what inverse 100 % should look : Capture pump 2.PNG tab mark " unknow " Is where you select the master pump.
Alain
Ok copied. Master still running at 30 constant
Sent from my Pixel XL using Tapatalk
It is set to run constant from midnight to 7.00 am , what time now are you place ? Did you upload the programming to the pump ?
Alain
The screen shot I uploaded is from the master. Pulse is selected at 30
Sent from my Pixel XL using Tapatalk
Did you upload the programming ?
Alain
Yes
Sent from my Pixel XL using Tapatalk
Does the Apex recognize one port as master and one as slave? Or it does not matter
Sent from my Pixel XL using Tapatalk
Nope , the Apex does not make any difference between the 2 by itself , it's up to you to decide which one you want as a master . As for me , the master is on the left side and the slave on the right . When you program the slave , you have to refer to the master pump , then it will work correctly .
Alain
Ok thanks. I'll call Neptune I'm all check mated out. Thanks for your help!
Sent from my Pixel XL using Tapatalk
Post the other pump's schedule, and be sure you have a Reference pump selected for each and every schedule point that is using Mirror or Inverse.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
I will russ thanks. Gotta take the wife out for dinner. I'll follow up in the AM
Sent from my Pixel XL using Tapatalk
For now
Sent from my Pixel XL using Tapatalk
Bookmarks