Can some one help me please please.
Hi, I tried to update by apex to the newest firmware since I need it to setup my DOS and DDR.
I connected a LAN to the apex and tried the upgrade, things were going well then it suddenyl encountered a problem from block 60 + but decided to continue with the upgrade since there is no cancel button. It took around 30 mins then the update was finished but it says it can't connect to the apex. I can control my apex now status light is blinking yellow.
Please help me figure it out since most of my equipment are on off state now.
Please please
Sent from my iPhone using Tapatalk
Bookmarks