The Waveline pump is Apex ready. Do I connect the Waveline controller module to a 0-10V Variable Speed/Dimming outlet on the Apex base unit using a cat 5 cable?
The Waveline pump is Apex ready. Do I connect the Waveline controller module to a 0-10V Variable Speed/Dimming outlet on the Apex base unit using a cat 5 cable?
You can use a cat five but I wouldn't recommend it. But I would suggest using this one from marine depot you can control two things rather than just one with a regular Ethernet cable
https://www.marinedepot.com/Waveline...FIPHAC-vi.html
Thank you. Marine Depot cable is on backorder 3-6 months. Great ides to use a splitter.
Ok, don't know what some of these jokers have been smoking....but here's what worked for me:
1. Make one end of the ethernet cable to T568-B specs.
On the other end:
1. For VSP1 pin positions 5 & 6 with blu /whi (5) grn (6) [5 is + voltage and 6 is ground]
2. For VSP2 pin potions 5 & 6 with org/whi (5) & org (6). [5 is + voltage and 6 is ground].
As always check with voltage meter with VSP sliders to ON position for around 10 vdc, prior to crimping.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I should also note that I have the Apex 2016
Sent from my iPhone using Tapatalk
Bookmarks