-
New User
Is it possible?
Hi,
I want to turn a pump on with low lv sensor and shut it of with high lv sensor. Is it possible?
-
Frequent Visitor
What type of sensor? I do this with float switches
Sent from my SM-G930W8 using Tapatalk
-
New User
apex optical sensors. What is the code that you use? Should work the same.
I am trying to do a AWC. I have a ATK. I will be using the optical sensor form the ATK for max level and another apex optical sensor for minimum. I will be using apex solenoid out of the manifold to export the water to the drain and PMUP to refill salt water. All hooked up to 24 v outputs on apex.
This is how i have it now. It works ok. I am not sure how reliable it will be.
AWCLow = minimum water level in sump.
SLN = maximum water level in sump.
AWCvale
Fallback OFF
Set OFF
If Time 20:00 to 20:02 Then ON
If AWCLow OPEN Then OFF
If FloodS CLOSED Then OFF
If Sflood CLOSED Then OFF
AWCpmup
Fallback OFF
Set OFF
If Time 20:03 to 20:04 Then ON
If SLN CLOSED Then OFF
If FloodS CLOSED Then OFF
If Sflood CLOSED Then OFF
ATK
Fallback OFF
Set OFF
If SLN OPEN Then ON
If SLH CLOSED Then OFF
When On > 001:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
If Time 19:59 to 20:10 Then OFF
-
NSI Member
The easiest turn on when low and off at high is this
Fallback OFF
If Swx_Lo OPEN Then ON
If Swx_Hi CLOSED Then OFF
When On > 002:15 Then OFF
No Set OFF, this means once the bottom sensor activates and becomes covered it doesn't go back to the OFF state
Insert a time value at the end just slightly longer than it takes to fill your container. If thats 2 minutes, set this slightly higher with a little buffer in case it takes a bit longer than usual once and awhile. This is your emergency OFF if the sensors fail. It will send you an alert and put the tile into an OFF state.
-
New User
i Just figured this out 1 minute before you replayed.
what do you think about this?
AWCvale
Fallback OFF
If Time 10:00 to 10:02 Then ON
If AWCLow OPEN Then OFF
Defer 01:00 Then ON
AWCpmup
Fallback OFF
If AWCLow OPEN Then ON
If SLN CLOSED Then OFF
When On > 001:00 Then OFF
If Output AWCout = ON Then OFF
If Sflood CLOSED Then OFF
ATK
Fallback OFF
Set OFF
If SLN OPEN Then ON
If SLH CLOSED Then OFF
When On > 001:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 060:00 Then OFF
If Time 09:59 to 10:10 Then OFF
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks