Hey all,
I recently installed two PM-2's on my Apex. One is wired into my sump and the other is wired into my kalk reactor. What I have noticed is that when one is plugged in, it reads correctly. However, when both are plugged in, the readings are cut down. Obviously there is some interference here. How do I resolve it?
By the way, all my probe wires are run together with no other electrical wires.
And I wanted to add that the water in the kalkwasser reactor is not in contact with the water in the sump, there should be no way for the two probes to be interfering with each other in regards to stray voltage.
Bookmarks