Hi Guys,

i have expanded my system with a WMX module and two Vortech MP40's

But there is something weird going on.

I can't get them to 100% with the programming. When i switch the pump on the dashboard to On it wil go at full speed (100%)
When i put a point in with Constant Mode at 100%, the controller will go to 9 or 10 leds and the pump is not at full speed.

It does not matter which program i use, the speed is Always 20 - 30% less then what i set in the programming.

I am stuck at this and i can't figure out what causing this.

Anybody else that experienced this problem.

Greets,
Adri

MP40.jpg