Hi Guys,
i have expanded my system with a WMX module and two Vortech MP40's
But there is something weird going on.
I can't get them to 100% with the programming. When i switch the pump on the dashboard to On it wil go at full speed (100%)
When i put a point in with Constant Mode at 100%, the controller will go to 9 or 10 leds and the pump is not at full speed.
It does not matter which program i use, the speed is Always 20 - 30% less then what i set in the programming.
I am stuck at this and i can't figure out what causing this.
Anybody else that experienced this problem.
Greets,
Adri
MP40.jpg
Bookmarks