Results 1 to 5 of 5

Thread: sample rate

  1. #1
    Regular Vistor
    Join Date
    Nov 2016
    Location
    massachusetts
    Posts
    15

    sample rate

    Anyone know how to adjust the sample rate of temp in fusion ?

  2. #2
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,464
    What exactly are you asking about? The displayed numeric value? The graph data?
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

  3. #3
    Regular Vistor
    Join Date
    Nov 2016
    Location
    massachusetts
    Posts
    15
    Quote Originally Posted by RussM View Post
    What exactly are you asking about? The displayed numeric value? The graph data?
    Graph data thanks russM

  4. #4
    Master Control Freak RussM's Avatar
    Join Date
    Dec 2012
    Location
    California - US Pacific
    Posts
    22,464
    That is determined by the data logging interval.

    For Apex 2016, it is on the Misc page in both Apex Local and Fusion.

    For Apex Classic models, it is not available in Fusion. Use the Misc Setup page in the Classic Dashboard.

    The default is 10 minutes, which is good for normal use. I suggest leaving it at 10. Resist the urge to make it very short.
    Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.

  5. #5
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Quote Originally Posted by RussM View Post
    The default is 10 minutes, which is good for normal use. I suggest leaving it at 10. Resist the urge to make it very short.
    Depends on the intent. I set mine for 1 minute but I don't have a lot of devices. This gives me about 3 months of backlog. For tanks with several probes and 2 or more energy bars, I wouldn't go lower than 5. For larger tanks don't go lower than 10.

    For testing purposes though, I have always used 1 min for a couple weeks to make sure everything is working as intended then back off once I'm sure it all works right.

    You might be an engineer if...You have no life and can prove it mathematically.

Similar Threads

  1. Flow rate
    By Dfee in forum WAV Powerheads
    Replies: 2
    Last Post: 01-17-2021, 10:03
  2. SV-1 has poor flow rate
    By ensano in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 8
    Last Post: 05-15-2018, 08:29
  3. COR15 flow rate
    By Angeld480 in forum COR-15 & COR-20 Pumps
    Replies: 2
    Last Post: 04-03-2018, 08:32
  4. Dos rate
    By jelly in forum DŌS & DDR – Dosing and Fluid Metering System
    Replies: 6
    Last Post: 11-21-2017, 17:13
  5. Question: Rate of Change Alarming
    By tdunmore2 in forum Misc Apex Usage & Programming
    Replies: 0
    Last Post: 12-23-2016, 09:49

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •