Anyone know how to adjust the sample rate of temp in fusion ?
Anyone know how to adjust the sample rate of temp in fusion ?
What exactly are you asking about? The displayed numeric value? The graph data?
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
That is determined by the data logging interval.
For Apex 2016, it is on the Misc page in both Apex Local and Fusion.
For Apex Classic models, it is not available in Fusion. Use the Misc Setup page in the Classic Dashboard.
The default is 10 minutes, which is good for normal use. I suggest leaving it at 10. Resist the urge to make it very short.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Depends on the intent. I set mine for 1 minute but I don't have a lot of devices. This gives me about 3 months of backlog. For tanks with several probes and 2 or more energy bars, I wouldn't go lower than 5. For larger tanks don't go lower than 10.
For testing purposes though, I have always used 1 min for a couple weeks to make sure everything is working as intended then back off once I'm sure it all works right.
You might be an engineer if...You have no life and can prove it mathematically.
Bookmarks