I'm trying to get my AWC to be suspended so I can transfer the RODI and then mix the salt. Apparently my programming isn't working correctly.
I have a low water switch in my NSW tank (NSWLo) that I'm trying to use to suspend the water changes.
Is the command to turn off the DOS supposed to be on the outlet that the DOS is plugged into or on the actual water change outlet that's created when you hook up the DOS?
Shouldn't this work?
vNSWLo
If NSWLo OPEN Then ON
If Outlet vReset = ON Then OFF
NSWDos
Fallback OFF
Set OFF
If Time 20:00 to 21:30 Then WtrChange
If Time 10:00 to 11:30 Then WtrChange
If Outlet vNSWLo = ON Then OFF
If Outlet vHi = ON Then OFF
If Outlet vBsmtLeak = ON Then OFF
If Outlet vTankLeak = ON Then OFF
OSWDos
Fallback OFF
Set OFF
If Time 20:00 to 21:30 Then WtrChange
If Time 10:00 to 11:30 Then WtrChange
If Outlet vNSWLo = ON Then OFF
If Outlet vHi = ON Then OFF
If Outlet vTankLeak = ON Then OFF
If Outlet vBsmtLeak = ON Then OFF
Bookmarks