So I use a Tunze ATO. The water does travel a ways to the tank and the trickle fill is kind of slow. Sometimes I find the Tunze blinking RED because it didn't fill up enough before the five minutes were up.
Rather than having to turn it off - then back on - then off and back on a few times - I would like to program the Feed C button.
How would I program - if feed c --- then turn off - wait a brief time - turn on - then after 5 minutes turn off then back on.
I would like to repeat this cycle for as long as feed c is on.
Thanks for any help - I always appreciate it.!
Bruce
Bookmarks