I use kalkwasser in my top off tank and I have noticed that the siphon break will clog with precipitated kalk. Thank goodness for that float valve.
Any tricks to combat this?
I use kalkwasser in my top off tank and I have noticed that the siphon break will clog with precipitated kalk. Thank goodness for that float valve.
Any tricks to combat this?
Elevate the pump an inch or two on something or hang it elevated so it can't pull precipitate from the bottom of the container. Won't eliminate it completely but will help a ton.
You might be an engineer if...You have no life and can prove it mathematically.
You could also replace the supplied siphon break with a DIY one less prone to clogs. Basically run the line through a tee and from the tee run a 3ft length of airline up a wall and install a check valve on that (pointing in). The extra height will keep debris out of the check valve.
You might be an engineer if...You have no life and can prove it mathematically.
I think I found the check valve. Will this work?
https://www.bulkreefsupply.com/ozone...eck-valve.html
Probably. Manufacturers rarely post psi specs and it's impossible to calculate before hand without those. More than likely it will, but will require some experimentation to determine a height that will create enough vacuum pressure with the pump off to open the check valve and prevent breaking pressure without going high enough that the air compresses too much to prevent a full break. You are essentially trying to duplicate the physics of the vacuum break used in your toilet, in cars, and in sprinkler systems.
You might be an engineer if...You have no life and can prove it mathematically.
No. You have to test it (its a pretty complex fluid mechanic problem with too many unknowns to calculate). It's likely 3 ft will work but it depends on the check valve and the pump. Just cut a few different length (like 1 2 3 4 and 5 ft) and see which one is most reliable.
You might be an engineer if...You have no life and can prove it mathematically.
Bookmarks