Results 1 to 5 of 5

Thread: ATK does not run

  1. #1
    New User
    Join Date
    Mar 2016
    Location
    Atlanta
    Posts
    7

    ATK does not run

    I have hooked up the ATK today and my have yet to see it run, used configuration under task and set it up. I can turn the pump on and of with fusion but ATK will not work on its own. I an a newbie to I am sorry if this is simple for the rest of yall. Also after an hour it goes from auto to off on its own. Thanks for the help

  2. #2
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Make sure the inputs are set to optical and not water on floor.

    You might be an engineer if...You have no life and can prove it mathematically.

  3. #3
    Frequent Contributor zombie's Avatar
    Join Date
    Dec 2013
    Location
    Denver, CO
    Posts
    13,176
    Also make sure the pump is plugged into the FMM and the power supply is plugged into an outlet that has power and plugged into the FMM.

    You might be an engineer if...You have no life and can prove it mathematically.

  4. #4
    New User
    Join Date
    Mar 2016
    Location
    Atlanta
    Posts
    7
    Ok, so after trying all you suggestions nothing, adjusted so both sensors weren't under after and readjusted to where it needed to be and all is working know, don't know but it worked.


    Sent from my iPhone using Tapatalk

  5. #5
    New User
    Join Date
    Mar 2016
    Location
    Atlanta
    Posts
    7
    Thank you for all the input, it was very helpful.


    Sent from my iPhone using Tapatalk

Similar Threads

  1. ATK with PMUP v2 - run dry
    By DanATL in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 1
    Last Post: 04-30-2022, 09:48
  2. Can the ATK be run with the PMUP plugged into a DC24v port instead of powering the ATK with AC?
    By powers2001 in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 7
    Last Post: 11-29-2018, 17:41
  3. Review My Program Only run ATK at midday
    By Tastee in forum Apex Programming for Dosing, ATO, and AWC
    Replies: 3
    Last Post: 07-06-2018, 22:39
  4. Help! Two COR-15 cant run alongside a PMUP or ATK
    By Synergetic in forum COR-15 & COR-20 Pumps
    Replies: 6
    Last Post: 02-02-2018, 19:36
  5. Not able to run Task Setup for ATK
    By CluelessReefer in forum Fluid Monitoring Module (FMM), FMK, ATK, LDK, and FMM Accessories
    Replies: 8
    Last Post: 11-27-2017, 18:38

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •