I am using the optical sensor for water level in display tank. I want my return pump to shut off if sensor is submerged. How do I do that?
I am using the optical sensor for water level in display tank. I want my return pump to shut off if sensor is submerged. How do I do that?
Add this to the end of your return pump code and replace Switch with whatever you named the optical sensor.
If Switch CLOSED Then OFF
You might be an engineer if...You have no life and can prove it mathematically.
Thank you. That worked great. Since I am using the optical sensor to shut off my pump incase of a drain clog. I want the pump to stay off until I can remove the clog. What is the code the keep the pump turned off.
Depends on what your current code is. Mind posting the entire outlet code?
You might be an engineer if...You have no life and can prove it mathematically.
Fallback ON
Set ON
If FeedA 003 Then OFF
If Swx4_1 CLOSED Then OFF
There are a couple ways, but this is probably the best.
Create a virtual outlet. I'm calling it DrainClog
DrainClog
Set OFF
If Swx4_1 CLOSED Then ON
Defer 000:10 Then ON
When On > 000:10 Then ON
Return
Fallback ON
Set ON
If FeedA 003 Then OFF
If Outlet DrainClog = ON Then OFF
You might be an engineer if...You have no life and can prove it mathematically.
That worked. Thanks for your help.
Bookmarks