Hello There!
We were just headed out the door for a fun-fill 4th of July break and before I left I noticed one of my fuge outlets was not operating. I decided to power cycle my Apex unit and upon turning back on my EB8 showed a status of green but no power was being distributed through the outlets. As if that wasn't bad enough I tried to jump on fusion and found out my modem went out. After plugging a computer into my APEX and reestablishing an internet connection was I was able to access the classic dashboard and update all of my modules and FW to 4.52_5A17. Now with all current SW on my 3 EB8s (all were OK before the update) and other modules I began to look around a little more and noticed that all of my outlets on one EB8 (EB8_3) were either renamed or given random names (e.g., "�- (1-240) or appeared to be a child under the parent outlet.
Apex Outlets.png
Some of the outlets went from say Light1 to Chiller or Heater and so one, completely random. All the other EB8 outlets appear to be correct. Further more I am unable to connect to Fusion to verify my DOS pumps configuration and WAV settings. So, now that my outlets for the EB8_3 have been reprogrammed, what do I do with these random outlets? Also, I can't find my alarm or email outlets.
As far as Fusion goes, I have disconnected my Apex and tried to add it again via token but now all I see is a communication error (below). Any help would be appreciated. Thanks, Devon
ApexFusion Communication Error.png Apex Module List.png
Bookmarks