I cannot figure out how to program "feed mode" to simply turn off the outlet I have my power head plugged into in Fusion. I click into the outlet to enter code but there is no "advanced" drop down area to enter code.
I cannot figure out how to program "feed mode" to simply turn off the outlet I have my power head plugged into in Fusion. I click into the outlet to enter code but there is no "advanced" drop down area to enter code.
Unless you are using a variable speed pump (vortechs, 0-10, WAV, etc.) It's in the drop down labeled "control type". This will automatically convert your existing code to advanced and you can add the feed statement at the end.
You might be an engineer if...You have no life and can prove it mathematically.
Thanks! Now that I changed control type to advanced the code doesn't seem to be working.
Fallback ON
Set ON
If FeedA 000 Then OFF
Did you upload it?
You might be an engineer if...You have no life and can prove it mathematically.
how do you get your powerhead to run constantly when in auto? I only want my powerhead to turn off when feedA is on..
Actually figured it out, just forgot the set on command. However I would like to set a 45 second delay before the powerheads come back on. Anyone know the command for that?
Bookmarks