So on my DOS (Alk & Cal) and my BRS Doser(MAg) is not showing in the output log. Even though it is enabled under each. What am I doing wrong or is there something I'm missing?
So on my DOS (Alk & Cal) and my BRS Doser(MAg) is not showing in the output log. Even though it is enabled under each. What am I doing wrong or is there something I'm missing?
Wait for Russ or Zombie (or others) for the official answer on this, but my speculation is the run time on your doser is shorter than the sampling time for the output log. The sampling time, on mine at least is 15 minutes. My BRS dosers usually only run for a few seconds each cycle.
When you are using the Fusion wizards to program your outputs, then the logging is considered as always ON, so you will not see the output turning ON and OFF in the Output Log, however if you click on the name of the DOS Tile it will take you to the DOS logging
Capture.PNG
Capture1.PNG
Jon
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
Bookmarks