Output log Not Showing Dosing

[jtgrimes]

So on my DOS (Alk & Cal) and my BRS Doser(MAg) is not showing in the output log. Even though it is enabled under each. What am I doing wrong or is there something I'm missing?

[clsanchez77]

Wait for Russ or Zombie (or others) for the official answer on this, but my speculation is the run time on your doser is shorter than the sampling time for the output log. The sampling time, on mine at least is 15 minutes. My BRS dosers usually only run for a few seconds each cycle.

[jonmos75]

When you are using the Fusion wizards to program your outputs, then the logging is considered as always ON, so you will not see the output turning ON and OFF in the Output Log, however if you click on the name of the DOS Tile it will take you to the DOS logging

Capture.PNG

Capture1.PNG

[RussM]

my speculation is the run time on your doser is shorter than the sampling time for the output log. The sampling time, on mine at least is 15 minutes. My BRS dosers usually only run for a few seconds each cycle.

Output state changes are logged as they happen (if logging is enabled). The "sampling time", as you put it, is called the Datalog Interval, and that only applies to logging of the values for inputs such as probes and flow sensors.