I had some start up issues yesterday with my ATK installation. At that time I also used the Task section to install a flat surface leak detector in the FMM. Yesterday when I came home the sump was low and the top off pump would not run.
I removed the leak detector and reset everything and was able to get back running normally.
Today the ATK is running correctly
Now I would like to reinstall the leak detector again.
here are my symptoms:
as soon as I plug the leak detector in the FMM it goes into alarm (orange flashing and audible)
I went to task area and attempted to run the "add leak detector" It will not step past the module selection of the setup, as there is a circle with a line thru it when I run the cursor over it. (same if I try to rerun the add ATK task.)
what should I try to resolve this?
thanks
Bookmarks