So, I decided to go with a single Gyre pump with the icecap controller, but while I have code for a dual pump set up, I cannot figure out how to make a code for a single Gyre pump.
What I want to do is:
Gyre runs at 40% constant mode from 11:00 AM to 4:00 PM
Gyre runs at pulse mode (say 60%) from 4:00 PM to 7:00 PM
Gyre runs at 40% constant mode from 7:00 PM to 12:00 AM
Gyre goes into night mode at 25% from 12:00 AM to 11:00 AM
I am computer stupid. Honestly, I am. This theoretically should be easy, but for someone who isn't computer literate or savvy, it's not as easy as you would think.
Just thinking outloud, I would need a profile for the constant mode (do I use pump? Ramp?). I guess I would make the min/max at 40% but it's the ramp (if I use that) time that confuses me.
I would need a pulse profile, which I can figure out (using pump), Off Time: 0, On time 10, Off time 10, Min Intensity: 25, Max Intensity: 60
Then I would need a night mode profile (I guess this would be ramp?)
Then comes the programming of the virtual outlet for the gyre, which I have no clue how to do for a single pump.
Then I need to set up the programming in the variable speed outlet...another that I have no clue how to do for a single pump.
Bookmarks