So I am attempting to set up the DOS for auto water changes.
Plugged in the device, hooked the tubes up and calibrated it.
So issue is this-if I just run on "on" it works fine both importing the NSW and shipping out the OSW. However when I use the magic wand per se to run this over a period of 13 hrs (8 am to 9 pm) the NSW component seems to work fine but I think it's running into issues with the draw for the OSW as the rotations per second isn't high enough?
This is the program that was set up for the OWS. I know what the first component is after tdata obviously but I am not sure what the rest of the string means.
Fallback OFF
Set OFF
If Time 08:00 to 20:59 Then ON
tdata 08:00:00,1,3,3,112,4,56,43,3,122,1,44,18,0
Also realized after the sump had filled a little too much I need some float switches for safety!
Any assistance on these issues greatly appreciated.
Lawrence
Sent from my iPhone using Tapatalk
Bookmarks