So i got my tank filled today and removed the caps from my probes and put them in the holders. I noticed the pH was low, around 3 so i decided to run a cal. Probe didnt budge off 195 in 7 or 10 solution. unplugged probe, replugged, disabled, enabled, rebooted. i'm guessing a bad probe but before i go down that route i wanted to see what the community thought. thanks.
You cannot calibrate out a gross error like that. Contact tech support.
Please do not send me PMs with technical questions or requesting assistance - use the forums for Apex help. PM me ONLY if the matter is of a private or personal nature. Thanks.
i didnt calibrate it....probe never responded when put in solution.
Support has been contacted. Any other suggestions from the community ?
Posting Permissions
Reply With Quote
Bookmarks