I just ordered a bunch of gear on the 10% off sale.
DOS
2X SOLENOIDS
PM2, temp prob, salinity monitor
LSM and LEDs
2nd Break out box
Etc...
My Set up is 3 tanks. A 225 display, a 90g qt and a 40g mixing station, all plumbed with 3x water lines and drainage lines run by pumps.
I decided to set up the DOS on continuous water change around 1.8 gpd
I had originally bought the pm2 to monitor salinity as a novelty...thought a back up temp prob would be good and with the second break out box I'll have both high and low sensors in both sumps, both ato Reservoirs and mixing stations.
All of my water lines are on brs float switches.
I had bought the solenoids as back up shut offs for my atos should my float valves fail and my high sensors get set off.
It occurs to me however with a salinity monitor, high and low level monitors for my mixing station, a DOS and a solenoid switch I might be able to do something very creative with my continuous water change situation.....
Ideas?????
Sent from my SM-G950U1 using Tapatalk
Bookmarks