I have been using the DOS for AWC for awhile with little trouble until recently. I use the below code to have the AWC only run on certain days as I try to do a 4 gallon WC a couple days of the week dependent on when I get my 5 gallon supply and waste bucket changed out. For example I expect the below program to run on Wednesday. Then Thursday or Friday I will change out the buckets and change the DoW code to Saturday. Until recent this method was working OK. Recently the DOS is not running at all but when I check the DOS logs it shows it running the day before but no water was exchanged. For example, today (Wed) the DOS Output is set to Auto and it says ON but nothing is running and the outputs for Add and Remove are set to Auto but state there are off. But yesterday they stated TBL and the the logs show it ran every hour even thought the DOS output was indicating off and was program not to run until Wednesday and no water was exchanged.
Any Ideas?
Fallback OFF
Set OFF
If DoW ---W--- Then ON
If Output PumpMain_3_3 = OFF Then OFF
If Swx21_1 CLOSED Then OFF
Bookmarks