Hi All,
I am completely new to Apex following many years with a GHL system. I am sure this has been covered so sorry for asking for help here. I have not programmed anything so far on the unit beyond simple socket function.
What I want to achieve is to automate my RO reservoir and RO flushing. I want to use a high and low optical float switch to trigger the RO unit turning on and off. I then have a solenoid on the main feed to the RO unit and on the flush. It also has a booster pump that needs turned on. So want the following:
1. Float switch shows reservoir low.
2. Turn on main RO feed and booster pump.
3. Turn on membrane flush for 1 minute.
4. Flush membrane for 1 minute each hour.
5. This keeps going until float switch shows reservoir full.
6. Flush membrane for 1 minute.
7. Off and wait for low sensor again.
Can this be achieved? If so I would really appreciate an idea on how to code it.
Thank you in advance.
Regards,
Andrew.
Bookmarks