I am new to Apex and have been reading tons of stuff on programming, but I am unable to find a solution. (Even looking at the negative of what I am trying to do.
I am trying to determine the correct Syntax for an email Alert if there is 0 Watt at the Heater outlet when it is on, but only after a delay. When I have the Alert set to 1 W on the Heater_2_4W Config, I get an alert everytime the Temp drops below the threshold, that then the Alert Cancels 1 min later when the Heater turns on. I need a delay to allow time for the heater to turn on.
I tried If Heater_2_4W <1 Min Time 010 Then ON
The email Alert page will not recognize the Watt meter at Heater_2_4W.
I am also not sure if it will accept Min Time on an Alert
Please advise.
Bookmarks